
9-Channel Energy Management Actuator
9-channel 16 A module that switches circuits and measures current, voltage, power and consumption, with alarms and energy-saving control.
KNX 9-channel 16 A energy management execution module. It switches lighting and loads, handles scenes and measures current, voltage, active power, power factor and energy consumption, with alarms and early warnings.
- Brand
- Seawin
- Family
- Actuators
- Protocol
- KNX
We install it for you
Design, cabling, ETS programming and hand-over: everything is included in our quote.
Our home-automation tradeWhat this product brings
- Independent control of 3/6/9 16 A lighting or load circuits
- Manual forced-cut dial and relay with magnetic latching
- On/off delay, timed off and cycle switching
- Status value query and reply
- Selectable relay state after bus power failure and voltage recovery
- Scene combination control to suit different scenes
- Logic operations on two levels: logical AND and logical OR
- Single-phase energy measurement on 3/6/9 circuits: current, voltage, active power, power factor, energy consumption, etc.
- Several measurement sending modes: on request, periodic, on change, and periodic plus change combined
- Abnormal alarm values adjustable per channel for current, voltage, active power, power factor and consumption, with an alarm signal sent to the bus when a value is abnormal
- Strategy control: current, voltage, active power, power factor and consumption thresholds set per channel for precise relay control and energy savings
Often installed with this product

4-Channel 20 A Switch Actuator
MR0420Four 20 A outputs on a DIN rail to switch lights and loads, with manual override, scenes and a dry contact input.
View product
6-Channel 20 A Switch Actuator
MR0620Six 20 A outputs on a DIN rail to switch lights and loads, with manual override, scenes and a dry contact input.
View product
8-Channel 20 A Switch Actuator
MR0820Eight 20 A outputs on a DIN rail to switch lights and loads, with manual override, scenes and a dry contact input.
View product
12-Channel 20 A Switch Actuator
MR1220Twelve 20 A outputs on a DIN rail to switch lights and loads, with manual override, scenes and a dry contact input.
View productInterested in this product?
A technician visits you free of charge, checks compatibility with your installation and gives you a detailed quote within 24 hours.